[Woodcarver] patterns

[Gene and Darlene Bremmer]

Charley
Here is the instructions to make a pattern from Irfanview....Ones that I got in 2002, so I assume they are still the same or very similar. 
Gene


Open a photo and do the following:

Image->Effects->Edge Detection
Image->Negative
Image->Convert to Grayscale

After you convert to Grayscale go to:

Image->Enhance Colors and decrease the gamma (to the left) and you will get better lines and detail. I used around 1.00 gamma correction..


That is the info for making patterns as I have it....Gene.....    (Good Luck)




--------------------------------------------------------------------------------


  Thanks Gene & Darlene and Al & Sue

  downloaded the irfanview program but it looks to hard to try tonite  . tomorrow sounds good. will try yours too AL&Sue.

  thanks again....

  I have several patterns but can't find them... wanted to try a different one anyway
   
  Charley 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://six.pairlist.net/pipermail/woodcarver/attachments/20080108/6aaa2819/attachment.htm>