[Woodcarver] Airbrush tools

[dinokruz at aol.com]

The NEO is made FOR iwata avaliable at.hobbylobby at $69 and use a  
40%.coupon can net u.one cheap. I.havent used one but iwata sponsored says  
something.

I would order a 3mm paasche VL NO accessories from bearair. If u buy a kit  
the hose is 6foot too short in my opinion. I would then buy a 10 foot hose.

You can buy bottle adapters at.hobbylobby for hobbypaint.bottles or createx  
brand paint.  Which.turns the bottle into a siphon.feed bottle of dedicated  
paint. One for green one for.blue etc

The paasche comes with a gravity feed cup that slides on the gun and holds a  
cap full if paint. As the iwata hp-c has a dedicated cup for small amounts  
of paiint.

There are numerous off brand airbrushes that will handicap ur attempts to  
learn save urself the headache and buy a nane brand.

A compressor of 3/4 horse or better will support any volume type painting.  
Hobby compressors will run constantly and possibly not support the cfm  
needed dependinng on ur usage. If course if your painting fishing lures that  
might work for your application. 40lbs psi is typical ~ I often spray at  
80lbs for long periods. If u paint cakes 40lbs will land your frosting on  
the ceiling. A water moisture trap is a must.

Ajrbrushaction magazine is a great read. Check out the airbrush forum on  
line

Good luck
DinoKruz

Connected by DROID on Verizon Wireless

-----Original message-----
From: Gary A Crosby <darkwood at darkwood-woodcarving.com>
To: "[Woodcarver]" <woodcarver at carverscompanion.com>
Sent: Sun, Feb 19, 2012 23:02:04 GMT+00:00
Subject: [Woodcarver] Airbrush tools

Good-day all, I am looking at picking up an airbrush kit and  
compressor, if any of you out there in carving land, has any  
recommendations as to what I should consider picking up and where to  
pick it up I would appreciate it, thanks

Gary & Marie

darkwood-woodcarving.com



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://six.pairlist.net/pipermail/woodcarver/attachments/20120219/543a0809/attachment.htm>