[Woodcarver] terminology explaination (was cutting angles)

[Merrilee Johnson]

Ok Larry,
Now I have a guestion - when I am sewing, the side of the fabric with the 
brightest color/print (shows on the outside), is called the right side of 
the fabric. This I understand but I have seen "put the boards with the face 
side down on the table" and wasn't sure what that meant exactly.  So to 
double check if I understand this - is that the side of the board you want 
your design on?  And as Jean said no laughing and pointing please :)
Thanks!
Merrilee


>From: "Larry Robertson" <workinginwood at hotmail.com>
>Reply-To: "[Woodcarver]" <woodcarver at six.pairlist.net>
>To: "[Woodcarver]" <woodcarver at six.pairlist.net>
>Subject: Re: [Woodcarver] Cutting  Angles
>Date: Sun, 17 Oct 2004 10:00:47 -0400
>
>To make a DONATION to the Mailing List using PayPal OR regular mail, click 
>this link: http://wwwoodcarver.com/WWWList/WWWList.html
>
>Hi Jean,
>If I understand what you are asking you have to set the bandsaw table at 15 
>degrees and rip both pieces with the face side down on the table.
>
>Larry Robertson
>Colchester, Ontario
>www.picturetrail.com/workinginwood
>----- Original Message ----- From: "Jean Athey" <atheyjm at yahoo.com>
>To: "Woodcarver MailList Submission" <woodcarver at six.pairlist.net>
>Sent: Saturday, October 16, 2004 5:53 PM
>Subject: [Woodcarver] Cutting Angles
>
>
>>To make a DONATION to the Mailing List using PayPal OR regular mail, click 
>>this link: http://wwwoodcarver.com/WWWList/WWWList.html
>>
>>Hello all,
>>I'm stumped at what should be an easy task, but I'm
>>new at marking and cutting angles. I've got two
>>12"x12" boards that are each 3/4" thick (1x12 stock.)
>>I want to stand these two boards on end and cut a
>>miter so that the two 12" sides form about a 60 degree
>>angle when glued together--as if you opened a book
>>that was 12" tall and set it on end with the two
>>covers fanning open to a 60 degree angle. I've tried
>>setting my bandsaw table at several angles, but can't
>>come up with the correct cut when the two  3/4" thick
>>boards are matched along the sides. If anyone
>>understands what I'm trying to achieve, please tell me
>>how to do it. And no pointing and laughing!
>>Jean
>>
>>
>>
>>
>>
>>_______________________________________________
>>Woodcarver mailing list
>>Woodcarver at six.pairlist.net
>>http://six.pairlist.net/mailman/listinfo/woodcarver
>>
>_______________________________________________
>Woodcarver mailing list
>Woodcarver at six.pairlist.net
>http://six.pairlist.net/mailman/listinfo/woodcarver

_________________________________________________________________
Don’t just search. Find. Check out the new MSN Search! 
http://search.msn.click-url.com/go/onm00200636ave/direct/01/