[Woodcarver] Carving letters in oak boards

[Linehan718 at aol.com]

In a message dated 5/15/2008 4:56:19 P.M. Eastern Daylight Time,  
mfrumer at yahoo.com writes:

Joe Dillett suggested a RotoZip and said that it would not be difficult  to 
use. Is it likely to be easier than using a router? I have not  used either and 
was told that it would be almost impossible to control a  router without a 
template. If I use the RotoZip, I assume I should get the  router attachment for 
it. Correct?
 
Mike




Rotozip is similar to a router, as are laminate trimmers just not as  
powerful.  Due to the power and weight of a router, it can be rather hard  to 
control.  whichever machine you decide to use, you will need to practice  till you 
are able to have good control.  The better you are, the better the  free handing 
will be.  There are templates available for lettering  also.
 
 
Maura Carving in NYC
_www.carvinginnyc.com_ (http://www.carvinginnyc.com/) 
_http://mycarvingclub.com/mauramacaluso_ 
(http://mycarvingclub.com/mauramacaluso) 









**************Wondering what's for Dinner Tonight? Get new twists on family 
favorites at AOL Food.      
(http://food.aol.com/dinner-tonight?NCID=aolfod00030000000001)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://six.pairlist.net/pipermail/woodcarver/attachments/20080515/12e445ee/attachment.html>